AstroStart RSS-2524 User Manual download pdf (Page 13)

The following table shows the effect that each zone has on the rearming cycle.

Protection zone Effect on rearming cycle

Hood

Doors

Additional sensor (trunk)

Shock sensor

These four zones prolong rearming cycle as long as they remain in violation.

Ignition

Activated by ignition key: Cancels rearming

Activated by remote starter: No effect

Warning No effect

Applying brakes or ignition key in RUN position cancels rearming (until a door is opened, which causes rearming cycle to

restart from the beginning).

See also "TEMPORARY VALET MODE" (page 12) and "DOME LIGHT DURATION" (page 13).

You can disarm only with the remote control by sending the lock command (see Table of Commands on page 5).

System is disarmed immediately and restarts rearming cycle from the beginning.

TO TERMINATE ALARM CONDITION

You can send the unlock command which also terminates the alarm condition and disarms the system or send either of the

lock or stop command which terminates the alarm condition without disarming the system.

CONFIRMATION

When the alarm is armed, one chirp of the siren and/or flash of the parking lights means that all protection zones are in

normal condition and system is ready.

Three chirps or flashes means that one or more zones are in violation (i.e. at least one door is opened).

Once the zone is corrected (i.e. door closed), the system sends another confirmation (one chirp or flash if all zones are in

normal condition, three chirps or flashes if another zone is in violation).

If a zone is in violation when system is armed manually (using remote) and the cause of the violation is not corrected, the

alarm will still arm but this zone will not be able to generate an alarm condition. See also "DOME LIGHT DURATION" on

page 13.

When you disarm the alarm, two chirps or flashes indicate that no one tried to break into your vehicle, and four chirps or

flashes indicate that an alarm condition occurred during your absence.

The following table summarizes this section.

CONFIRMATION MEANING

1 chirp or flash System armed, no zone in violation.

2 chirps or flashes System disarmed, no violation detected.

3 chirps or flashes System armed with zone in violation. Indicator light indicates which zone.

4 chirps or flashes System disarmed with violation detected. Indicator light indicates cause of alarm condition.

INDICATOR LIGHT

Indicator light flashes a specific number of times to indicate different conditions of the security system when arming and

disarming the system (depends on programming).

It can also act as a deterrent if installed in a place visible from outside the vehicle.

DURING ARMING Indicator flashes codes for zones in violation (i.e. at least one door is opened).

Only one code is shown at a time. If more than one zone is in violation during arming, code changes when zone shown is

corrected (example: door closed).

DURING DISARMING Indicator flashes code for last zone that generated the alarm condition.

Code is shown when you send an unlock command.

This code is repeated until you apply the brakes.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

AstroStart RSS-2524 User Manual Page 13

Comments to this Manuals

Related products and manuals for Remote starters AstroStart RSS-2524