AstroStart RSS-2524 User Manual download pdf (Page 19)

ALARM CONDITION CODES

Use this command to identify which zone is in violation during arming or which generated alarm condition.

Refer to the table of command on page 5 to know which button to press.

Parking lights will flash number of times corresponding to code for protection zone in violation.

If more than one zone is in violation, code for the zone with highest priority is shown (1 = highest priority).

See table of codes below.

Code Protection Zone Priority

System is armed. 8

A door is/was open. 1

Hood is/was open. 3

Alarm condition is/was detected on shock sensor input. 5

Key is/was in the RUN position. 2

Alarm condition is/was detected on additional sensor input.

Additional sensor monitors status of __________________________________________________

Loss of power (+12V battery supply was removed). 7

More than 3 warnings were given within 3 minutes by pre-shock input. 6

CODE LEARNING OF ADDITIONAL TRANSMITTER(S)

Four different remote controls can be programmed for a given vehicle. If a fifth remote is added, the first remote is deleted.

Note: When the first code learning command is sent, all the old codes are cleared out. Therefore if you want to add a new

remote, all the old ones must be reprogrammed as well.

One or more remote transmitters can be added. To do this, the programming is accessed as follows:

 Open hood. (Hood switch must be present and operational. – See “Safety checks” on page 17.)

 Place key in the ignition and turn to the RUN position

 Apply the brakes once

 You now have 10 seconds to turn the key from the RUN to the OFF position 3 times.

 If this sequence is correctly carried out, the control module flashes parking lights (4 flashes). You may then

proceed to the next step.

 Press the

button on the new remote control. When access code of new remote control is memorized,

the control module will confirm with flashing parking lights (1 flash).

 Repeat the above procedures for each remote control that has to be programmed (up to 4 remotes).

 Apply the brakes.

New remote(s) is (are) now added to the system.

If your vehicle is equipped with a function that automatically sets driver preferences (seat, mirrors, etc.) and the system is

configured to control it, the remote controls programmed in positions 1 and 2 will control the settings for the first driver and

the remote controls programmed in positions 3 and 4 will control the settings for the second driver. If you only have two

remote controls, program the first one twice and the second one twice to occupy the four memory locations of the system.

SAFETY CHECKS

In order to maintain a high safety standard, proceed with the following checks every month.

HOOD SWITCH

• Remote start your vehicle.

• Open hood.

Engine should stop as soon as hood is opened.

If engine does not stop immediately, turn main switch to OFF position and leave it off until situation is rectified.

Contact

your service center.

1 2 ... 14 15 16 17 18 19 20

Comments to this Manuals

No comments

AstroStart RSS-2524 User Manual Page 19

Comments to this Manuals

Related products and manuals for Remote starters AstroStart RSS-2524